Shrink Packaging Machine Operation And Attention

Shrink packaging machine first use to shrink the products together, after the first close, there will be a film on the packaging of the goods, but this time the packaging effect is not very good, after the second close after the effect is very good. Such as food, beer outside the plastic film packaging, packaging out of the appearance is very beautiful, the heat shrink machine can also be with the disinfection dryer together, constitute a package of complete equipment.

1. Shrink packaging machine and winding machine the same because of consumption of power is very large, so the power input power must be greater than the nominal power on the shrink machine nameplate, otherwise easy to burn the line or electrical components.

2. The shrink packaging machine must be grounded reliably like a baler to protect personal safety.

3. When each machine leaves the factory, it is attached with a cable connecting the power supply. The terminal lead part has the identification symbol of the power supply.

4, when the shrink packaging machine voltage for three-phase 380V power supply, must be input at the same time the zero line, that is, the standard three-phase four-wire system of other packaging equipment is also like the vacuum packaging machine. Otherwise the machine can not work properly, and easy to burn internal electrical components.

5, the machine must be installed horizontally, otherwise it will shorten the service life of the electric heat pipe. For the net belt conveyor machine, its tilt installation will cause the conveyor belt to deviate from the center.

6. If the shrink packaging machine is continuously used for more than three months, the heat-resistant wire in the shrinkage chamber shall be inspected and replaced according to its aging degree.

7. When the shrink packaging machine is working, the operator's palm and other parts are not allowed to contact with the operating parts of the machine, especially the extremely high temperature in the contraction chamber, which is easy to scald.

8. After the packaging is finished, the heating switch should be turned off first, and the conveying motor and the fan motor should continue to run for about 10 minutes, then the whole power supply should be cut off.