Position: Home » Product Wiki » How To Maintain A Luggage Wrapping Machine
How To Maintain A Luggage Wrapping Machine
If the luggage wrapping machine fails, it will affect the work efficiency in light, and in severe cases, it will cause damage to the luggage wrapping machine and cause unnecessary losses. So how to maintain the luggage wrapping machine?
1. Before starting the machine, it is necessary to check whether the components of the luggage wrapping machine are in good condition; whether the screws and nuts of each component are loose, and if so, they should be tightened in time. If parts are missing, repair personnel must be notified to deal with them in time.
2. Before operation, check whether there is any debris in the conveyor rail. If there is debris, it must be removed.
3. Check whether the knife group and the slide part are short of oil. Use the method of dipping and dripping oil to add oil. Use a small stick to dip the oil and slowly drip it on it. It cannot flow into the conveyor rail by pouring it down, otherwise the packing belt will slip .
4. If abnormal phenomena are found during the startup process, such as loud sound, large vibration, peculiar smell, etc., you need to stop the machine for repair. If you can't repair it yourself, you should stop the machine and notify the repair personnel to deal with it, so as to avoid damage to the parts.
5. When operating the luggage wrapping machine, attention should also be paid to prevent misoperation so that the luggage wrapping machine can be hit without tape, so as not to damage some wearing parts.
6. After the luggage wrapping machine is used, the power should be cut off, and it should be noted that it cannot be turned off immediately and left。
7. It is necessary to develop the good habit of adding lubricating oil frequently. According to the frequency of use of the luggage wrapping machine, drip an appropriate amount of special lubricating oil into the air inlet of the luggage wrapping machine regularly. Each lubricating place of the machine should be as required, and at least add lubricating oil per shift. Add lubricating oil once.
8. After working for a long time, a special wire brush should be used to clean the plastic-steel belt stuck on the tightening wheel and the anti-slip sheet to prevent slipping when pulling the belt.
1. Before starting the machine, it is necessary to check whether the components of the luggage wrapping machine are in good condition; whether the screws and nuts of each component are loose, and if so, they should be tightened in time. If parts are missing, repair personnel must be notified to deal with them in time.
2. Before operation, check whether there is any debris in the conveyor rail. If there is debris, it must be removed.
3. Check whether the knife group and the slide part are short of oil. Use the method of dipping and dripping oil to add oil. Use a small stick to dip the oil and slowly drip it on it. It cannot flow into the conveyor rail by pouring it down, otherwise the packing belt will slip .
4. If abnormal phenomena are found during the startup process, such as loud sound, large vibration, peculiar smell, etc., you need to stop the machine for repair. If you can't repair it yourself, you should stop the machine and notify the repair personnel to deal with it, so as to avoid damage to the parts.
5. When operating the luggage wrapping machine, attention should also be paid to prevent misoperation so that the luggage wrapping machine can be hit without tape, so as not to damage some wearing parts.
6. After the luggage wrapping machine is used, the power should be cut off, and it should be noted that it cannot be turned off immediately and left。
7. It is necessary to develop the good habit of adding lubricating oil frequently. According to the frequency of use of the luggage wrapping machine, drip an appropriate amount of special lubricating oil into the air inlet of the luggage wrapping machine regularly. Each lubricating place of the machine should be as required, and at least add lubricating oil per shift. Add lubricating oil once.
8. After working for a long time, a special wire brush should be used to clean the plastic-steel belt stuck on the tightening wheel and the anti-slip sheet to prevent slipping when pulling the belt.
